Skip to content

Services / Chipping and painting

Chipping and painting on ship

Chipping and painting is how a ship's crew keeps corrosion off the steel. Below is the job step by step, and the stores we deliver so your crew can do it in port.

How chipping and painting is done on board

  1. 1

    Chip and descale

    Knock off loose paint and rust scale with chipping hammers, scrapers or a pneumatic needle scaler; use a deck scaler on large flat areas.

  2. 2

    Clean to sound steel

    Wire-brush or power-tool the area until only firm, well-bonded paint and bare steel remain, then feather the edges of the old coating.

  3. 3

    Wash and dry

    Remove salt and dust with fresh water and let the surface dry completely. Salt left under new paint brings the rust straight back.

  4. 4

    Prime the same day

    Bare steel starts rusting again within hours, so spot-prime it on the day it is cleaned, and only when the steel is at least 3 °C above the dew point.

  5. 5

    Build up the coats

    Apply intermediate and top coats from the vessel's coating system, keeping to the paint maker's overcoating interval between coats.

Before starting, wear eye and ear protection and a dust mask, keep paint and thinner work ventilated, and follow the vessel's permit system for work aloft or overside.

What we supply for the job

Chipping and descaling

Chipping hammers, scrapers, wire brushes, needle scalers and spare needles, deck scalers, grinding and wire-cup discs.

Painting equipment

Brushes, rollers, roller frames and extension poles, paint trays, masking tape and mixing sticks.

Paint and thinners

Primers, intermediate and top coats, and thinners, quoted against the products named in your vessel's coating specification.

Safety gear

Goggles and face shields, ear protection, dust masks and respirators, gloves and coveralls.

These ship with the rest of your deck and engine stores, at the ports we cover in India, Sri Lanka and the UAE.

Request a quote

Questions

What is chipping and painting on a ship?

It is the routine maintenance the deck crew carries out to stop corrosion: rust and failing paint are chipped away, the steel is cleaned, and new primer and paint are applied. Decks, hatch coamings, rails and superstructure are painted in rotation.

What tools are used for chipping on a ship?

Hand chipping hammers and scrapers for small areas, pneumatic needle scalers for edges, welds and pitted steel, and deck scalers for large flat surfaces, followed by wire brushes or power tools to finish the surface.

Can you supply paint to our vessel's coating specification?

Yes. Send the paint maker and product names from your coating specification with the requisition, and we quote those products where they are available at the port. If one is not, we tell you before delivery rather than substituting.

Do you provide painting crews?

No. We supply the tools, paint and safety gear; the work is done by your crew.